Husqvarna GTH2548XP Owner's Manual page 8

ASSEMBLE GAUGE WHEELS TO MOWER
DECK (See Fig. 4)
The gauge wheels are designed to keep the mower deck
in proper position when operating mower. Be sure they
are properly adjusted to ensure optimum mower perfor-
mance.
• Slide gauge wheel bar down into bracket channel, Be
sure that gauge wheel bar aligning holes are on top.
As sem ble gauge wheels as shown using shoulder bolts,
3/8 washers and 3/8-16 center locknuts and tighten
securely.
• For ease of mower to tractor assembly, raise gauge
wheels to highest position and retain with clevis pins
and spring retainers.
• Adjust gauge wheels before operating mower. See "TO
ADJUST GAUGE WHEELS" in the Operation sec tion
of this manual.
RETAINER SPRING
PIN
AD JUST ING
SHOULDER
BAR
BOLT
GAUGE
WHEEL
3/8 WASH ER
ASSEMBLY
3/8-16 CENTER
LOCKNUT
FIG. 4
TO ATTACH NOSE ROLLER
(See Fig. 5)
• Assemble brackets "A" and "B" to the inside of mower
mounting brack ets as shown. Tighten securely.
NOTE: Be sure bracket tabs are po si tioned in tab holes
in mower brackets.
• Position nose roller between brackets and install rod
and retainer spring.
TAB
HOLE
"A"
BRACKET
RETAINER SPRING
8
HEX
BOLT
LOCK
ROD
NUT
"B"
BRACKET
NOSE
ROLLER
FIG. 5