Husqvarna EZ4220 Operator's Manual page 46

Deck belt installation
NOTE: For ease in installing the deck belt, refer to the
routing decal on the front edge of the deck.
•
Wrap the deck belt around the electric clutch that is
located on the engine shaft.
•
Push the rest of the belt through the IZT(Integraded
Zeroturn Transaxle) support and up onto the deck.
•
Starting on the right hand side of the deck, wrap
the belt around the large right side idler, right cutter
housing pulley, small center idler, center pulley, left
side pulley and then around the large left side idler.
•
The belt will be loose at this point.
•
Using a ratchet with a 9/16" socket on the spring
idler bolt to relieve the tension on the belt. See
decal on the top of deck for belt routing information.
•
After installation is complete check the belt for
twists.
MAINTENANCE
1. Clutch pulley
2. Deck belt
3. Spring idler pulley
4. Fixed idler pulley
Belt routing, deck belt
Slackening the belt tensioner
1
2
4
3
4
8058-007
8011-622
47
-
English