LG DLG2522W Service Manual page 11

3-wire connection : Direct wire
Important : use 3-wire connection in the places
such as mobile homes and areas where 3-wire
connections is not available.
Prepare minimum 5ft(1.52m) of length in order for
1 /
3 "
2
dryer to be replaced.
(8.6 cm)
First, peel 3 / inch (8.9cm) of covering material
1
2
from end and bare 1 inch from the ends.
Then, put the hooked shape end of the wire under
the screw of the terminal block(hooked end facing
rightward) and pinch the hook together and screw
tightly.
1. Connect neutral wire(white) of power cord to
center terminal block screw.
2. Connect red and black wire to the left and right
terminal block screws.
3. Make sure that the strain relief screw is tightened
and be sure that all terminal block nuts are on
tight and power cord is in right position.
a
• lf your local codes or ordinances do not allow the
C
1. Connect the neutral wire (white) of the power
B
D
2. Connect the red and black wires to the left and
E
3. Connect the ground wire (green) of the power
4. Make sure that the strain relief screw is tightened
10
Option 1: 4-wire connection with
a Power supply cord.
use of a 3 wire connection, or you are installing
your dryer in a mobile home, you must use a 4-
wire connection.
a
b
cord to the center terminal block screw.
right terminal block screws.
cord to the external ground screw. Remove the
neutral ground wire of appliance and connect it to
center screw.
and that all terminal block nuts are tight and the
power cord is in the right position.
D
E
F
C