Connecting To A Dvd Player Via Hdmi; Connecting To A Dvd Player Via Component Sockets (Ypbpr) Or Scart Cable - Sharp LC-32SH130E Operation Manual

• Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
• Only two partitions on a HDD unit can be
supported.
• Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
• Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.

Connecting to a DVD Player via HDMI

Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
• If your DVD player has an
connect via HDMI for better video and audio quality.
• When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player via
Component Sockets (YPbPr) or
Scart Cable
If you want to connect a DVD player to your LCD
TV, you can use connectors of the TV set. DVD
players may have different connectors. Please refer
to your DVD player's instruction book for additional
information. Power off both the TV and the device
before making any connections.
Note: Cables shown in the illustration are not
supplied.
• If your DVD player has an HDMI socket, you can
connect via HDMI. When you connect to DVD player
as illustrated below, switch to HDMI source. See,
"Input Selection" section.
• You may also connect through the scart socket. Use
a SCART cable as shown below.
A01_MB60_[GB]_1910UK_IDTV_TC_PVR_NICKEL16_32883W_YPBPR_ROCKER_10073212_50190084.indd 12 A01_MB60_[GB]_1910UK_IDTV_TC_PVR_NICKEL16_32883W_YPBPR_ROCKER_10073212_50190084.indd 12
Note: These two methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
HDMI socket, you can
•
HDMI Cable
(not supplied)
External device
•
•
English - 12 -
Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). In this case,
you must use the supplied Component video
connection cable for enabling connection. First,
plug single jack of the cable to the TV's YPbPr
socket (side). Afterwards, insert your component
cable's (not supplied) connectors into the socket
part of the Component video connection cable (see
illustration below). Colours of the connected jacks
should match.
To enable audio connection, use the
Audio cable. First, plug single jack of the cable
to the TV. Afterwards, insert your DVD player's
audio cable's connectors into the socket part of the
VGA/Component audio connection cable (see
illustration below). Colours of the connected jacks
should match.
When the connection is made, switch to
YPbPr source. See, Input selection section.
Note: To connect YPb Pr device, you should use supplied
component (YPbPr) connection cable.
VGA/Component
23.06.2011 14:02:59 23.06.2011 14:02:59