Calling Features - D-Link DVG-4032S User Manual

with them, and according to RFC standards. If any registration problem occurs, please consult your
Proxy Server provider.
NOTE: When you register with a Proxy Server, dialing principles may vary with different Proxy Servers,
especially when dialing through a remote end FXO port. Please consult your Proxy Server
Provider.

Calling Features

Unconditional Forward: All incoming calls will be forwarded to the "Forwarding Number"
automatically.
Busy Forward: Forward the incoming call to "Forwarding Number" when the port is busy.
No Answer Forward: Forward the incoming call to "Forwarding Number" after ring
timeout expires without answer.
Call Hold: Enable the call hold feature on the specific FXS port.
Call Transfer: Enable the call transfer feature on the specific FXS port.
Call Waiting: Enable the call waiting feature on the specific FXS port.
Three-Way Calling / Service ID: Feature code of conference call defined on Nortel Soft
Switch
Calling Feature Instructions:
Call Hold: Ongoing call will be put on hold after FLASH button pressed on the phone set.
The gateway will play a repeating music to the remote end.
Call Transfer: Ongoing call will be put on hold after FLASH button pressed on local
phone set (gateway plays a repeating music to the remote end). Meanwhile, local user
can dial out to another number after dial tone observed. After the handset is back on the
hook, the call on hold will then be transferred to the new call regardless of the status of
the new cal. If wrong number is dialed for the new call, just press the FLASH button to
get back the call on hold. In another case, if the local user doesn't hang up the phone
after new call sets up, press FLASH button to switch between the first call and the new
call. Please be informed that PBX between phone sets and the gateway must support
FLASH features to make this function work correctly. If a phone set is connecting directly
29