Quick Start - NEC MDview 243 User Manual

Quick Start

To connect the LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For a PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display controller in your
system (Figure A.1). Tighten all screws.
For a PC with Analog output (MDview 232/243 only): Connect a 15-pin mini D-SUB to DVI-A signal cable (not included) to
the connector of the display controller in your system (Figure A.2).
For an Apple: Connect an Apple to DisplayPort cable adapter (not included) to the computer, then attach the DisplayPort
cable to the Apple to DisplayPort cable adapter (Figure A.3).
NOTE: Some Apple systems do not require an Apple cable adapter.
For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display controller in your system
(Figure A.4).
Figure A.1
NOTE: 1. Please use a DisplayPort cable with a DisplayPort logo.
2. When removing the DisplayPort cable, hold down the top button to release the lock.
3. Height adjustment is locked by a lock button. Place hand on top of the monitor to push down the screen to the lowest
position. Slide the lock button to unlock (Figure B.1).
NOTE: Handle with care when unlocking the stand.
Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position.
Slide the cable cover up (Figure B.2).
NOTE: The cable cover is not removable.
Figure B.1
Apple Cable Adapter
Figure A.2
(not included)
Cable cover
English-4
DisplayPort cable
Figure A.3
30° Tilt
Figure B.2
Figure A.4