Table of Contents
Advertisement
Before requesting
service forthis unit, check the chart below f or
apossible cause ofthe problem you are experiencing.
Some sim-
ple checks oraminor adjustment
onyour part m ay e liminate
the
problem and restore proper operation.
If youareindoubt about
some of the check points, or if the
remedies indicated
in the chart do not solve the problem, refer to
the directory
of authorized
service
centers (enclosed
with this
unit) to locate a convenient
service
center,
or consult
your
Technics
dealer for instructions.
(In U.S.A. consult
MSC Authorized
Servicenters
for detailed
in-
structions.)
[
Problem
Probable cause(s)
I
Suggested remedy
J
Changer
will not play.
A disc(s) or other foreign
object(s) has fallen
• Open the loading drawer,
and then remove the
inside the changer,
object.
Moisture
has collected
in the changer.
• Switch on and allow the changer to dry out for about
one hour before using it.
The disc In the changer
• Make sure the label is facing upward.
does not play.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
Play stops before changing
to the next disc.
A certain music passage
can't be played correctly.
There Is noise from the
tuner or disturbance
on the
TV screen.
When program play Is
started,
an error message
(-E)
appears on the
display.
An error message
( _ E)
appears on the display, and
the changer stops
operetlng.
The loading drawer stops In
the middle of opening.
Remote control does not
operate correctly.
The disc is upside down.
The disc is dirty.
The disc is scratched.
The disc is warped.
The disc is not within specified
standards.
The loading drawer is open.
• Press the OPEN/CLOSE button to close the loading
drawer.
The disc is dirty.
• Wipe the disc with a soft cloth.
The disc is scratched.
• Replace the disc with a new one.
Caused by high-frequency signals from this
• Use the changer further
away from the tuner or IV.
changer.
• If the tuner or TV's antenna is the indoor type, use an
outdoor one.
Play was started without a track being
• Program a track.
programmed.
The mechanism
of the changer has been
improperly adjusted.
• Turn the unit off and then back on again.
However,
if the loading drawer is fully open, take out
the compact disc(s) at the front position and then turn
the unit off and then back on again.
The batteries
have run out.
• Replace batteries with new ones.
There is an obstruction between the remote
• Remove the obstruction.
control and the changer.
The batteries are inserted incorrectly.
• Reinsert batteries so that the polarities are correct.
[The (+) and (-)
polarities are reversed.]
Product
service
Do not attempt
to remove the cover(s) or repair the unit
yourself.
Refer servicing to qualified
personnel only.
Product
information
For product service, product information or assistance in pro-
duct operation, refer to the servicenter directory.
23
Advertisement
Table of Contents
