Check For Loose Hardware; Check Safety Labels - EarthQuake 14267 Operator's Manual

Maintenance
Schedule & Procedures
The following schedule should be followed for normal care of your unit.
SAFETY ITEMS

Check for loose hardware

Check all safety labels
Inspect cone, hopper, and guards.
CHIPPER MAINTENANCE ITEMS
Clean debris from engine and chipper. **
Inspect/Rotate Shredding Hammers
Inspect/Rotate Chipping Knives
ENGINE MAINTENANCE ITEMS
Check Engine Oil Level *
Change Engine Oil * **
Check / Change Engine Air Filter * **
Replace Spark Plug *
* Refer to engine owner's manual. Change original engine oil after initial break-in period of 5-8 hours.
** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
Check for Loose Hardware
Service Interval: Every 5 hours; every spring and fall.
Inspect the unit, checking for loose hardware or components.
Pay special attention to the hardware attaching the chipper
cone, hopper, axle, and front leg.

Check Safety Labels

Service Interval: Every spring and fall.
Check that the safety labels are in place and undamaged.
Sample illustrations and part numbers of the decals can be
found on page 6. Replace any damaged or missing decals.
16
Before Every 5 Every 25
Each Hours Hours
Use
X
Before Every 5 Every 25
Each Hours Hours
Use
X
Before Every 8 Every 25
Each Hours Hours
Use
X X
Inspect Cone, Hopper, & Guards
Service Interval: Every spring and fall.
Check that the chipper cone, shredder hopper, and discharge
guards are in place, undamaged, and secure. Replace any
damaged or missing parts.
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
Every 100 Every
Hours 250
Hours
Every 100 Every
Hours 250
Hours
X
X
X
Every 50 Every
Hours 100
Hours
X
X
Operator's Manual
Chipper/Shredders
Spring &
Fall
X
X
X
Spring &
Fall
Spring &
Fall
X