Standing By; Action Of The Tx/Rx Led; Related Settings - Icom IDAS IC-F3160 series Manual

3 Standing by

After the radio has successfully finished registering, it moves to a repeater assigned as the [Home
repeater] and enters the standby mode. Preprogrammed channel text is displayed on the radio's LCD.
The LED blinks green every several seconds. The LED blinking default interval is 5 seconds, but you can
adjust this to a longer or shorter interval.

Action of the TX/RX LED

1, 3, 5, 7. The radio stays on the [Home repeater] in the standby mode.
2, 4, 6. Receives a [Site ID] signal sent from the [Home repeater].
Site ID TX cycle (total duration time of the above chart 2+3) is adjustable.
Refer to items in "related settings" for details.

Related settings;

■Roaming Wait Timer (CS-F3160/F5060)
Default Value: 6 seconds
Value range: 0.1 to 25.5 seconds
This item sets the time duration that the radio
stays on the [Collect repeater] to find a [Site
ID] signal, after the radio is turned ON.
Set the timer 1 second longer than the Site ID
TX cycle.
If it is set shorter than the Site ID TX cycle, the
radio may fail to find a [Site ID] signal which is
a trigger for the radio to start the registration process.
■Site ID TX cycle (UC-FR5000)
Default Value: 5 seconds
Selectable range: 3 to 10 seconds
Set the time interval to transmit the
[Site ID] from the [Collect repeater]
and the [Home repeater] at a
Multi-site Trunked mode site.
Use the default value under normal
operation. If you adjust this value,
be sure it is longer than the radio's
"Roaming Wait Timer".
400 milliseconds (adjustable)
5 seconds (adjustable)
TTX-F3160/F5060-V1.0
7