Table Of Contents - Husqvarna 340 EPA II, 345 EPA II, 350 EPAI Operator's Manual

Before using a new saw
• Read the instructions carefully.
• Check cutting equipment is correctly fitted and adjusted.
See page 25.
• Refuel and start the saw. Check the carburetor settings.
See pages 26-29.
• Do not use the saw until sufficient chain oil has reached the
chain, see page 14.
IMPORTANT! If the carburetor mixture is too lean it greatly
increases the risk of engine failure.
Poor maintenance of the air filter will cause carbon build-up on
the spark plug and lead to difficult starting.
If the chain is badly adjusted it will cause increased wear or
damage to the bar, drive sprocket and chain.
Maintenance, replacement, or repair of the emission
control devices and systems may be performed by any
nonroad engine repair establishment or individual.
WARNING!
Under no circumstances may the design of
the machine be modified without the permis-
sion of the manufacturer. Always use genuine
spare parts/accessories. Non-authorized
modifications and/or accessories can result in
serious personal injury or the death of the
operator or others.
Your warranty may not cover damage or
liability caused by the use of non-authorized
accessories or replacement parts.
A chain saw is a dangerous tool if used
carelessly or incorrectly and can cause
serious, even fatal injuries. It is very important
that you read and understand these
instructions.
Warning! The inside of muffler contain
chemicals that may be carcenogenic. Avoid
contact with these elements in the event of
damaged muffler.
You will find the following labels on your chain saw:
EPA I:
EPA II:
The Emissions Compliance Period reffered to on the
Emissions Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emission requirements.
Category C = 50 hours, B = 125 hours, A = 300 hours.
CONTENTS
Key to symbols
Safety instructions
Personal protective equipment
Chain saw safety equipment
Inspecting, maintaining and servicing chain saw safety
equipment ............................................................................
Cutting equipment
How to avoid kickback
General safety precautions
General working instructions
What is what?
What is what? ....................................................................
Assembly
Mounting guide bar and chain ...........................................
Fuel handling
Fuelmix ..............................................................................
Fuelling ..............................................................................
Start and stop
Start and stop ....................................................................
Maintenance
Carburetor .........................................................................
Starter device ....................................................................
Air filter ..............................................................................
Spark plug .........................................................................
Muffler ................................................................................
Needle bearing maintenance ............................................
Adjustment of the oil pump (350) ......................................
Cooling system ..................................................................
Centrifugal cleaning "Air Injection" ....................................
Winter use .........................................................................
Daily maintenance .............................................................
Weekly maintenance .........................................................
Monthly maintenance ........................................................
Technical data
340 ....................................................................................
345 ....................................................................................
350 ....................................................................................
Emission Control Warranty Statement
Your warranty rights and obligations .................................
Husqvarna AB has a policy of continuous product development
and therefore reserves the right to modify the design and
appearance of products without prior notice.
Contents
...............................................................
............................................
................................................
................................................................
.........................................................
................................................
..............................................
2
4
4
8
10
16
18
19
24
25
26
27
28
29
30
31
31
31
31
31
32
32
32
33
33
33
34
34
34
35
3
English -