Product Record/Serial Plate Location; Important Safety Instructions - Kenmore 790. 7231 Series Use & Care Manual

Grounding Instructions
Avoid fire hazard or electrical shock. DO
NOT use an adapter plug, an extension cord, or remove
grounding prong from electrical power cord. Failure to
follow this warning can cause serious injury, fire or
death.
This appliance is equipped with a 3-prong grounding plug
for your protection against shock hazard and should be
plugged directly into a properly grounded receptacle.
DO NOT cut or remove the grounding prong from this DO NOT DO NOT DO NOT DO NOT
plug.
For personal safety, the range must be properly grounded.
For maximum safety, the power cord must be plugged into
an electrical outlet that is correctly polarized and properly
grounded.
If a 2-prong wall receptacle is the only available outlet, it
is the personal responsibility of the consumer to have it
replaced with a properly grounded 3-prong wall
receptacle installed by a qualified electrician.
Grounding type
wall receptacle
Product Record
In this space below, record the date of purchase, model
and serial number of your product. You will find the
model and serial number printed on an identification
plate. See bottom of this page for serial plate location.
790.
Model No. _____________________________________
Serial No. ______________________________________
Date of Purchase _______________________________
Save sales receipt for future reference.

Important Safety Instructions

Do not under any
circumstance, cut,
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong
grounding plug.
Save these instructions for future reference.
See the INSTALLATION INSTRUCTIONS packaged with
this range for complete installation and grounding
instructions.
Conversion to L.P. Gas
Personal injury or death from electrical
shock may occur if the range is not installed by a
qualified installer or electrician.
Any additions, changes or conversions
required in order for this appliance to satisfactorily meet
the application needs must be made by a qualified
technician.
This appliance allows for conversion to Liquefied
Petroleum (L.P.) Gas.
If L.P. conversion is needed, contact your local L.P. Gas
provider for assistance. The L.P. conversion kit is provided
with this appliance and is located on the lower REAR
(back side) panel of the range. Before installing the kit be
sure to follow the L.P. Installation Instructions carefully.
Serial Plate Location
To locate the serial plate open storage
drawer (some models) or warmer drawer
(some models). The serial plate is attached
to the lower right oven frame.
6