Table of Contents
Advertisement
12-2113.fm Page 12 Wednesday, July 14, 1999 12:18 PM
MOUNTING THE
STEREO
Once you verify that the stereo is
connected properly, follow these
steps to mount the stereo.
1. Disconnect the cable from the
vehicle battery's negative (–) ter-
minal.
Battery
2. Disconnect the wire harness and
the antenna.
Antenna
Connector
Vehicle's
Back of Stereo
Antenna
3. Press
on the right side of the
REL
control panel to remove it (see
"Removing the Control Panel" on
Page 15).
4. Insert both of the supplied keys
into the slots at the bottom left
and right sides of the stereo.
12
Vehicle Negative
Battery Cable
Wire Harness
Press the keys downward, and
slide the sleeve off of the stereo.
5. Remove the keys from the slots.
6. Put the sleeve into the dash,
then secure it by bending out all
the tabs with a screwdriver.
7. If your vehicle has an existing
mounting hole in the dash, use
pliers or a
5
/
-inch box-end
16
wrench to attach the supplied
washer and the short end of the
supplied mounting bolt to the
back of the stereo.
Hide quick links:
Advertisement
Table of Contents
