Changing The Brush Roller; Replacing The Brush Roller Pulley; Replacing The Swivel Neck - Windsor 1.012-052.0 VSP14 Operating Instructions Manual

Maintenance
27
27
38
39
14
27
27
26
27
29
X
86359940 VERSAMATICPLUS 14 & 18

Changing The Brush Roller

Remove the power head from the upper body.
To remove the power head cover, push the button
32
(32), remove the side plate (26) and remove the four
(VSP14) or five (VSP18) large screw (27) from under-
neath the chassis. The cover and the button (32) can
then be lifted off.
Push the belt (29) off the motor pulley (3), remove the
bumper (41). Remove the three screws from both
brush bearing blocks (42 & 43). Lift the bearing
blocks out and replace the brush roller.Re-assemble
bearing blocks, bumper, install belt, side plate and
cover. Attach upper body to power head.
27
30

Replacing The Brush Roller Pulley

To remove the brush roller pulley (35) hold the roller
in one hand and turn the pulley in a clockwise direc-
tion.
To remove the motor pulley (36), insert a screw driver
into a groove and give a light tap in a counterclock-
wise direction. The loosened pulley can then be
removed.
36
35

Replacing The Swivel Neck

37
To remove the swivel neck (37) take out the two small
screws (38) from the swivel neck supports (39) then
39
lift the swivel neck assembly from the chassis.
38
NOTE: On re-assembly ensure that the wires from
the swivel neck are not trapped when the power
head cover is replaced.