Sanyo PLC-XE30 Owner's Manual page 51

Settings
Set the sensitivity
Press the button 1 and then press the F button.
Then press one of the buttons below to select the
sensitivity. After completing the setting, you will hear the
high-pitched confirmation sound.
Button 1 .........highly sensitive (default setting)
Button 2 .........normal sensitivity
Button 3 .........less sensitive
✔
Note:
•This setting can be made only when the Antitheft alarm function is
off.
Set the length of alarm ringing time
Press the button 2 and then press the F button.
Then press one of the buttons below to select the length of
alarm ringing time. After completing the setting, you will
hear the high-pitched confirmation sound.
Button 1 .........about 10 seconds (default setting)
Button 2 .........about 60 seconds
Button 3 .........until the end of the battery life
✔
Note:
•This setting can be made only when the Antitheft alarm function is
off.
•When selecting Button 3, the length of alarm ringing time differs
depending on the battery life.
Change the PIN code
Press the F button and input the four-digit PIN code
1
within about 10 seconds. The ALARM indicator will
blink red for a few seconds and high-pitched
confirmation sound will be made.
2 While the indicator is blinking, input new PIN code
then you will hear the high-pitched confirmation sound
and the ALARM indicator will be off.
When inputting an incorrect PIN code, you will hear
low-pitched sound. If you input incorrect PIN codes 3
times, the alarm will start ringing.
A PIN code for Antitheft alarm function is the
combination of 1, 2, or 3. Input the PIN code with the
button 1, 2, and 3. The default PIN code is set as
"1111".
Side Control
CAUTION:
WHEN YOU HAVE CHANGED THE PIN
CODE, WRITE DOWN THE NEW PIN
CODE IN THE COLUMN OF THE PIN
CODE NO. MEMO ON PAGE 67, AND
KEEP IT SECURELY. IF YOU FORGET
YOUR PIN CODE, SOME SETTINGS OF
THE ALARM FUNCTION CAN NO
LONGER BE CHANGED.
http://www.pureglare.com.au
Antitheft Alarm Function
F button button 1, 2, 3
ALARM
indicator
51