Cub Cadet Commercial S6031 Tank S Operator's Manual page 11

4. Install the upper ROPS section onto the lower ROPS "posts".
Install the (1⁄2-13 x 3.25) HHCS bolts, nuts and washers. See
Fig. 3-3.
Hex Bolts
Washers
Lower ROPS Posts
Figure 3-3
5. Tighten Upper ROPS section bolts after both RH & LH
hardware is installed.
6. Tighten the frame mounting hardware to 80-90 lb.-ft.
torque. See Fig. 3-2.
NOTE: Make sure tubular upright posts are absolutely tight
within welded bracket.
7. Insert rubber plugs into each side of the upper ROPS. See
Fig. 3-4.
Rubber Plug
Figure 3-4
Nuts
8. Move the upper ROPS section to the upright position, and
insert the locking pins with their retainer hairpin clips. See
Fig. 3-5.
Locking Pin
Figure 3-5
Position Steering Wheel
The steering wheel of the tractor has been left off for shipping
purposes. Using the hardware found in the manual bag, the
steering wheel must be secured to operate the tractor. To install
the steering wheel for operation, proceed as follows:
1. Slide steering wheel over the steering shaft. See Fig. 3-6.
Steering
Shaft
Washer
Figure 3-6
2. Slide washer over steering shaft and secure using hex nut.
3. Snap steering wheel cover onto steering wheel.
s
ectiOn
Hairpin
Clips
Steering
Wheel
Steering
Wheel
Cover
Hex Nut
2 — a & s -u
sseMbly et p
11