Subaru Impreza 2004 Service Manual page 166

Engine section 2
Hide thumbs Also See for Impreza 2004:
Table of Contents

Advertisement

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1
CHECK DTC P0705 ON DISPLAY.
2
CHECK INPUT SIGNAL FOR ECM.
1)Turn the ignition switch to ON.
2)Measure the voltage between ECM and
chassis ground in selector lever "N" and "P"
positions.
Connector & terminal
(B134) No. 8 (+) — Chassis ground ( − − − − ):
3
CHECK INPUT SIGNAL FOR ECM.
Measure the voltage between ECM and chas-
sis ground in selector lever except for "N" and
"P" positions.
Connector & terminal
(B134) No. 8 (+) — Chassis ground ( − − − − ):
4
CHECK POOR CONTACT.
Check poor contact in ECM connector.
5
CHECK INPUT SIGNAL FOR ECM.
Measure the voltage between ECM and chas-
sis ground.
Connector & terminal
(B134) No. 8 (+) — Chassis ground ( − − − − ):
6
CHECK HARNESS BETWEEN ECM AND IN-
HIBITOR SWITCH CONNECTOR.
1)Turn the ignition switch to OFF.
2)Disconnect the connectors from ECM and
inhibitor switch.
3)Measure the resistance of harness between
ECM and inhibitor switch connector.
Connector & terminal
(B134) No. 8 — (T7) No. 12:
Check
Is DTC P0705 indicated?
Is the voltage less than 1 V?
Is the voltage 4.5 — 5.5 V?
Is there poor contact in ECM
connector?
Is the voltage more than 10 V? Repair battery
Is the resistance less than 1
Ω?
EN(H4DOTC)(diag)-245
ENGINE (DIAGNOSTICS)
Yes
Inspect DTC
Go to step 2.
P0705 using "List
of Diagnostic
Trouble Code
(DTC)". <Ref. to
EN(H4DOTC)(dia
g)-74, List of Diag-
nostic Trouble
Code (DTC).>
Go to step 3.
Go to step 5.
Go to step 4.
Go to step 5.
Repair poor con-
Contact your Sub-
tact in ECM con-
aru distributor ser-
nector.
vice.
NOTE:
Inspection by DTM
is
required,
cause
cause is deteriora-
tion
of
parts.
Go to step 6.
short circuit in har-
ness between
ECM and inhibitor
switch connector.
Go to step 7.
Repair harness
and connector.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
ECM and inhibitor
switch connector
• Poor contact in
coupling connector
• Poor contact in
inhibitor switch
connector
• Poor contact in
ECM connector
No
be-
probable
multiple

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents