Two-Piece Front Turn Signal Lamps - GMC Jimmy 2004 Owner's Manual

Two-Piece Front Turn Signal Lamps

1. Remove the headlamp assembly as shown in
"Two–Piece Composite Headlamp System"
under Headlamps on page 5-51.
3. Unplug the electrical connector.
5-54
2. Locate the locking tabs
on the assembly.
Squeeze the tabs
together and push that
end of the assembly
out while holding
the tabs. The assembly
will swing out.
4. Turn the harness bulb socket counterclockwise to
remove it.
5. Pull the bulb straight out to remove it from the socket.
6. Push the new bulb into the socket until it snaps into
place.
7. Reinstall the harness bulb socket with the new bulb
into the headlamp assembly and turn it clockwise
until it is tight.
To reinstall the assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in and snap it into place.
8. Install the two retaining clips.
9. Close the hood.