Table of Contents
Advertisement
AT&T DMOH
Important Notes:
1. The downloading process starts when audio signal is sensed, ensuring that
memory capacity will not be consumed during tape leader travel or for a delay of
the audio recording.
2. The audio RCA outputs do not operate during the downloading process.
Recording stops (and the RECORD indicator will go out) when 4 seconds of silence
has elapsed following the recording, or when memory capacity is exceeded, or when
the cassette tape reaches the end of its travel. After the message has been
downloaded, the cassette automatically rewinds, and should be stored in the tape
compartment for reloading after power outages.
Following the downloading process, the message will play continuously (the PLAY
LED will illuminate). To properly adjust the volume level for telephone message
output, the following steps should be followed:
Slide speaker monitor switch to off position.
·
Connect the unit to the telephone system through the LINE 600 ohm output or 1
·
WATT output, refer to page 9 for system wiring connections. If telephone system
has MOH volume control, set it to approximately 1/2 output level.
Place a call to your telephone from another telephone.
·
Place the calling telephone on hold.
·
Adjust DMOH volume control to obtain a comfortable listening level. If level is
·
not acceptable, adjust telephone system MOH volume.
Advertisement
Table of Contents
