Troubleshooting - Daewoo DWD-F1011 Service Manual

MESSAGE ERROR
WATER INLET
IE
ERROR
DRAIN
OE
ERROR
UNBALANCE
UE
ERROR
DOOR OPEN
LE
ERROR
OVERFLOW
E2
ERROR
LEAKAGE
E4
ERROR
HIGH VOLTAGE
E5
ERROR
E6
EMG ERROR
MOTOR
E8
ERROR
SENSOR PRES-
E9
SURE ERROR
THERMISTOR
H2
WASH ERROR
THERMISTOR
WASH
H4
OVERHEATING
ERROR
38 TROUBLESHOOTING GUIDE
CAUSE
The water tap is closed.
The filter of the valve inlet is clogged.
The valve inlet is an inferior product or broke down.
The water level sensor (sensor pressure) is an inferior product
or broke down.
The drain motor works during water supply.
The PCB ASS'Y does not check the water level.
The drain hose is kinked or clogged.
The drain motor is an inferior product.
The valve inlet works during drain.
The water level sensor is an inferior product.
The PCB ASS'Y does not check the water level.
The laundry is concentrated to one side of the drum during spin. Rearrange the laundry.
The Start/Hold button is pressed while the door is opened.
The switch door lock is an inferior product.
The PCB ASS'Y does not check the door lock.
The water is supplied continuously due to an inferior valve inlet.
The valve inlet is normal, but the water level sensor
(sensor pressure) is inferior.
The drain motor dose not work.
(The drain motor is an inferior product or broke down.)
Water leaks from the tub or the hose drain.
The laundry is jammed between the gasket and the drum.
The PCB ASS'Y is an inferior product.
The laundry is jammed between the gasket and the drum.
The motor is an inferior product.
The PCB ASS'Y is an inferior product.
The motor is not normally connected.
The motor does not work.
(The motor is an inferior product or broke down.)
The water level sensor is an inferior product.
The thermistor wash is an inferior product or broke down.
The thermistor wash is not connected normally.
The heater worked without the water in the tub.
The thermistor wash is an inferior product or broke down.
SOLUTION
Open the water tap.
Clean the filter of the valve inlet.
Change the valve inlet.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Change the PCB ASS'Y.
Clean and straighten the drain hose.
Change the drain motor.
Change the valve inlet
Change the water level sensor.
Change the PCB ASS'Y.
Close the door.
Change the switch door lock.
Change the PCB ASS'Y.
Change the valve inlet.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Check the leak of the tub or the hose drain.
Then change the tub or the hose drain.
Rearrange the laundry.
Change the PCB ASS'Y.
Rearrange the laundry.
Change the motor.
Change the PCB ASS'Y.
Check the connector of the motor.
Change the motor.
Change the water level sensor.
Change the thermistor wash.
Check the connector of the thermistor wash.
Check the water level.
Change the thermistor wash.