Storage Areas; Glove Box; Resetting Defaults - GMC 2004 Yokon Denali Owner's Manual

Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink ."

Resetting Defaults

®
To reset HomeLink to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
1-800-355-3515, or on the internet at
www.homelink.com.
®
® ®
using a HomeLink
®
button. Do
®
®
®
at

Storage Areas

Glove Box

To open your glove box, lift up the latch and pull the
door open.
Cupholder(s)
Your vehicle is equipped with cupholders for the front
and rear passengers.
The cupholders are located in the center console for the
front passengers and on the rear of the center console
for the rear passengers.
To use the front cupholders, press down on the access
door and release. The door will then open. Push the
door back down to close it.
To use the rear cupholders, pull down on the door
located on the back of the console.
2-43