Meter Description - Jensen JTM-69A User Manual

Meter Description

1. Liquid Crystal Display
2. Range button
3. Hz/Duty Cycle button
4. Mode button
5. Rotary Function switch
6. COM jack
7. 10A Current jack
8. Hold button
9. Relative button
10. Backlight button
11. Positive input jack
Note: Tilt stand, fuse and battery compartment are on rear of unit.
Symbols
AC Alternating current or voltage
DC Direct current or voltage
•))) Continuity
Diode test
mV, V millivolt, volt (voltage)
Ω, KΩ, MΩ
ohm, kilohm, megohm (resistance)
µA, mA, A microamp, milliamp, Amp (current)
nF, uF nanofarad, microfarad (capacitance)
Hz kHz hertz, kilohertz (frequency)
% % duty cycle
O O
F, C Degrees Fahrenheit, Centigrade (temperature)
AUTO Autorange
BAT Low battery
HOLD Display hold
REL Relative
7 JTM-69A V2.0 10/07