Maintenance; Kits & Service Parts - NorthStar M36029L Installation, Operation And Maintenance Manual

WARNING! Disconnect spark plug wire from spark plug and release air pressure from system before performing

maintenance.

NOTE: All compressed air systems contain maintenance parts (e.g. lubricating oil, filters, separators), which are
periodically replaced. These used parts may be, or contain, substances that are regulated and must be disposed
of in accordance with local, state, and federal laws and regulations.
NOTE: Take note of the position and locations of parts during disassembly to make reassembly easier. The
assembly sequences and parts illustrated may differ for your particular unit.
Check lubrication levels. Fill as needed.
Daily or before each
Drain receiver tank condensation.
operation
Check for unusual noise or vibration.
Ensure belt guards and covers are securely in place.
Ensure area around compressor is free from rags, tools, debris, and flammable or explosive
materials.
Check safety/relief valves by pulling rings. Replace safety/relief valves that do not operate freely.
Weekly
Inspect air filter element. Clean if necessary.
Inspect for air leaks. Squirt soapy water around joints during compressor operation and watch for
Monthly
bubbles. Tighten fittings if necessary.
Clean exterior.
Change petroleum lubricant while crankcase is warm.
3 months or 500
hours
Replace air filter element.
12 months or 1000
hours
INSTALLING OIL DRAIN PORT
1. Place an oil pan below port before unscrewing oil drain plug.
2. Remove plug (bolt and washer) from crankcase.
Quickly screw in stub.
3. Install bolt and washer into stub after changing oil, or
remove stub and reinstall plug into port.
DRIVE BELT
Belts will stretch in normal use. Properly adjusted, a 5
pound force applied to the belt between the motor pulley
and the pump will deflect the belt about 1/2".
TO ADJUST DRIVE BELT:
1. Remove belt guard.
2. Loosen the four fasteners holding the engine to the
compressor.
3. Shift the engine in the proper direction. The belt
must be properly aligned when adjustment is made.
4. To align belt, visually center engine pulley to
compressor pulley.
6. If necessary, move the pulley on the engine shaft.
7. Check for proper belt tension (see diagram).
8. Tighten the four fasteners holding the engine to the
top plate.
9. Attach belt guard.
Kits and Service Parts
Air filter: Part #35409
Non-detergent Oil: Part #35605
Maintenance
6
Stub from manual bag
00882