Playback - Sony RDR-HXD890 Operating Instructions Manual

, If you have connected an audio component
to the DIGITAL OUT (COAXIAL) jack
and want to change the audio track for the
HDD (when "HDD Recording Format" is
set to "Video Mode Off" in the
"Recording" setup (page 119))/DVD-
RWs/DVD-Rs (VR mode) during
playback, set "Dolby Digital Output" in
the "Audio Out" setup to "Dolby Digital->
PCM" (page 115).
, Bilingual audio streams cannot be
recorded simultaneously from digital
broadcasts.
The sound is breaking up.
, The signal strength is low.
, Check aerial installation.
Recording/Timer recording/
Editing
The programme position cannot be
changed from the programme position
you are recording.
, Set the TV's input source to "TV."
Recording does not start immediately
after you press z REC.
, Operate the recorder only after "LOAD,"
"FORMAT," or "INFO WRITE"
disappears from the front panel display.
Nothing was recorded even though you
set the timer setting correctly.
, There was a power failure during
recording.
, The recorder's internal clock stopped due
to a power failure that lasted for more than
1 hour. Reset the clock (page 106).
, The channel was disabled after the timer
recording was set. See "Manual CH
Setting" on page 110.
, Disconnect the AC power cord (mains
lead) from the mains, and connect it again.
, The programme contains copy protection
signals that restrict copying.
, Another timer setting overlapped the timer
setting (page 54).
, There is no DVD inside the recorder.
, There is not enough disc space for the
recording.
, The recorder was in the process of
dubbing.
, A scrambled channel is selected.
Recording does not stop immediately
after you press x REC STOP.
, It will take a few seconds for the recorder
to input disc data before recording can
stop.
On-screen instructions may appear after
pressing x REC STOP. In this case,
follow the on-screen instructions.
Recording does not stop after you press
x.
, Press x REC STOP.
Timer recording is not complete or did
not start from the beginning.
, There was a power failure during
recording. If the power recovers when
there is a timer recording, the recorder
resumes recording.
Should the power failure continue for more
than 1 hour, reset the clock (page 106).
, Another timer setting overlapped the timer
setting (page 54).
, Disc space was not sufficient.
Contents previously recorded were
erased.
, Data that is not playable on this recorder
but was recorded on a DVD with a PC will
be erased from the disc when the disc is
inserted.

Playback

The recorder does not play any type of
disc (except HDD).
, The disc is upside down. Insert the disc
with the labelled side facing up.
, The disc is not correctly inserted.
, Moisture has condensed inside the
recorder. In this case, if the recorder is on,
leave it on (if it is off, leave it off) for about
an hour until the moisture evaporates.
, If the disc was recorded on another
recorder and was not finalised (page 39),
the recorder cannot play the disc.
129
,continued