3.2 Attentions
In each step, if user hears an IVR message of "setting successful", which means that user has
finished this step successfully. However, if user hears a "setting failed" message, please
check redo theat step again.
DVG‐6001G can work in bridge mode user should configure network parameters of WAN
port.
3.3 General Feature Codes for System Setting
Dial numbers
*114#
*150*a#
*152*a*b*c*d#
*153*a*b*c*d#
*156*a*b*c*d#
*158#
*111#
3.4 Static IP Configuration
Assuming the IP address of a DVG‐6001G device is:
IP:172.16.0.100 subnet mask: 255.255.0.0 gateway: 172.16.1.1
configured as follows:
1.
Insert a SIM card into the DVG‐6001G gateway
2.
The configuration mode: Dial the phone number of this SIM card. hear a message, then
enter "*150*1#", hang up when hear " setting successful" message;
D-Link Corporation.
Table 3‐3‐1 Feature codes for system setting
Features
Play the phone NO.
Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is
static IP address mode, *150*2# is DHCP mode
Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is
Configure subnet mask. a, b, c, d are the four fields of the
subnet mask
Configure the device gateway, a, b, c, d are the four fields of the
device gateway
Report the IP address
Restart
DVG-6001G User Manual
9