Yard Works 270-1252 Operator's Manual page 24

OPERATING YOUR LAWN MOWER
MOWING TIPS
NOTE: A sharp blade will greatly enhance the performance of the mower, especially
when cutting high grass.Be sure to check the blade and to sharpen it at least once per
year, as described in the Maintenance section.
• Verify that the lawn is free of stones, sticks, wires, and other objects that could damage
the blades or the motor. These objects could be accidentally thrown by the mower in
any direction, and could cause serious personal injury to the operator and to others.
• In order to prevent electric shock, do not operate the mower in damp or wet conditions.
• Do not mow in circles. Travel back and forth across the lawn.
• When cutting thick grass, reduce walking speed in order to allow for a more effective cut
and a proper discharge of the clippings. For a healthy lawn, always cut off one-third or
less of the total length of the grass. The average lawn should be approximately 1-1/2 to 2"
(3.8 to 5 cm) long during cool months, and more than 2" (5 cm) long during hot months.
If there is growth, the lawn should be cut in the fall.
MULCHING TIPS
NOTE: ALWAYS INSPECT AREA WHERE MOWER IS TO BE USED AND REMOVE ALL
STONES, STICKS, WIRE, BONES AND OTHER DEBRIS WHICH MIGHT BE THROWN
THE ROTATING BLADE.
• Release switch to turn mower OFF when crossing any graveled area (stones can be
thrown by the blade).
• Set mower at highest cutting height when mowing on rough ground or in tall weeds.
• For effective mulching, do not cut wet grass, as it tends to stick to the underside of the
deck preventing proper mulching of grass clippings. New or thick grass may require
a narrower cut. The ground speed should be adjusted to the condition of the lawn. If
mowing has been delayed and the grass has been allowed to grow in excess of 4", mow
twice to reduce the grass height to 3-3/4" maximum.
• Walk at a good, steady pace. Overlap your rows. Don't let the grass get too tall. If the
grass gets too long start at the highest cutting position and work down to the desired
cutting height.
WARNING
If you strike a foreign object, stop the motor and . Thoroughly inspect the mower for any
damage. Repair any damage before operating the mower. Excessive vibration of the
mower during operation is an indication of damage. Thoroughly inspect the mower and
repair any damage before operating the mower.
24