Table of Contents
Advertisement
Instrument Panel Indicators
Turn Signal and Hazard Warning
Indicators
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicators do not blink
or they blink rapidly, it usually
means one of the turn signal bulbs is
burned out (see page
180
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you turn on the hazard
warning button, both turn signal
indicators blink. All turn signals on
the outside of the vehicle should
flash.
56
''Daytime Running
Lights'' Indicator
Canadian models only
This indicator comes on when you
turn the ignition switch to the ON
(II) position with the headlight
switch off and the parking brake set.
It should go off if you turn on the
headlights or release the parking
brake. If it comes on at any other
time, it means there is a problem
with the DRL. There may also be a
problem with the high beam
headlights.
Cruise Control Indicator
If equipped
This indicator comes on when you
set the cruise control. See page
120
for information on operating the
cruise control.
High Beam Indicator
This indicator comes on with the
high beam headlights. For more
information, see page
62
.
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page
62
).
Low Fuel Indicator
This indicator comes on as a
reminder that you must refuel soon.
When the indicator comes on, there
is about 1.6 U.S. gal (6 ) of fuel
remaining in the tank before the
needle reaches E. There is a small
reserve of fuel remaining in the tank
when the needle does reach E.
Advertisement
Chapters
Table of Contents
