Operation - Craftsman 919.184192 Owner's Manual

Oil lube, single stage, vertical stationary air compressor
Hide thumbs Also See for 919.184192:
Table of Contents

Advertisement

Available languages

Available languages

1.
Make sure the On/Auto/Off lever is
in the "Off" position.
2.
Check oil level in pump. See "Oil"
paragraph in the Maintenance
section for instructions.
3.
Recheck all wiring. Make sure
wires are secure at all terminals
connections. Make sure all con-
tacts move freely and are not
obstructed.
4.
Open the globe valve fully to per-
mit air to escape and prevent air
pressure build up in the air tank
during the break-in period.
5.
Move the On/Auto/Off lever to
"On/Auto" position. The compres-
sor will start.
6.
Run the compressor for 20 min-
utes. Make sure the globe valve
is open and there is minimal air
pressure build-up in tank.
7.
Check all air line fittings and con-
nections/piping for air leaks by
applying a soap solution. Correct
if necessary. NOTE: Minor leaks
can cause the air compressor to
overwork, resulting in premature
breakdown or inadequate perfor-
mance.
8.
Check for excessive vibration.
Readjust or shim air compressor
feet, if necessary.
9.
After 20 minutes, close the globe
valve. The air receiver will fill to
"cut-out" pressure and the motor
will stop.
Before Each Start-Up:
1.
Place On/Auto/Off lever to "Off".
2.
Close the globe valve.
3.
Attach hose and accessories.
grasp air hose in hand when
installing or disconnecting to
prevent hose whip.
use damaged or worn accessories.
Risk of unsafe
operation. Firmly
Risk of unsafe
operation. Do not
NOTE: A regulator MUST be installed
when using accessories rated at less
than 175 Psi.
NOTE: The hose or accessory will
require a quick connect plug if the air
outlet is equipped with a quick con-
nect socket.
pressure causes a hazardous risk of
bursting. Check the manufacturer's
maximum pressure rating for air
tools and accessories. The regulator
outlet pressure must never exceed
the maximum pressure rating.
Compressed air from the unit may
contain water condensation and
oil mist. Do not spray unfiltered air
at an item that could be damaged
by moisture. Some air tools and
accessories may require filtered
air. Read the instructions for the air
tools and accessories.
How to Start
1.
Turn the On/Auto/Off lever to "On/
Auto" and allow tank pressure to
build. Motor will stop when tank
pressure reaches "cut-out" pres-
sure.
2.
When the tank pressure reaches
"cut-out" pressure open the globe
valve.
IMPORTANT: When using regula-
tor and other accessories refer to the
manufacturers instructions.
is noticed, stop the compressor
immediately and have it checked by
a trained service technician.
The compressor is ready for use.
15-ENG
15-ENG
Risk of Bursting.
Too much air
Risk of unsafe

operation.

:
If any unusual
noise or vibration
N001248

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents