Cabinet Disassembly Instructions - Emerson EWL20S5 Service Manual

CABINET DISASSEMBLY INSTRUCTIONS

1. Disassembly Flowchart
This flowchart indicates the disassembly steps for the
cabinet parts, and the CBA in order to gain access to
item(s) to be serviced. When reassembling, follow the
steps in reverse order. Bend, route and dress the
cables as they were.
[8] Speaker (s)
[1] Rear Cabinet
[2] Jack Holder
[3] Inverter CBA
[4] Main CBA
[6] Function CBA
[7] IR Sensor CBA
[9] Front Cabinet
2. Disassembly Method
Step/
Loc. Part
Fig.
No.
No.
Rear
[1] D1 12(S-1), (S-2), 4(S-3)
Cabinet
[2] Jack Holder D2 3(S-4), (S-5)
4(S-6), *CN301,
Inverter D2
[3] *CN302, *CN303,
CBA D3
*CN304, *CN310
6(S-7), *CN1201,
D2 *CN1202, *CN1205,
[4] Main CBA
D3 *CN1206, *CN1207,
*CN801
LCD
[5] D2 13(S-8)
Module
Function
[6] D2 3(S-9)
CBA
IR Sensor
[7] D2 2(S-10)
CBA
4(S-11),
[8] Speaker (s) D2
Speaker Holder(s)
[5] LCD Module
Removal
Remove/*Unhook/
Unlock/Release/
Note
Unplug/Unclamp/
Desolder
---
---
---
---
---
---
---
---
Step/
Loc. Part
Fig.
No.
No.
Front
[9] D2 ---------------
Cabinet
↓ ↓ ↓
(1) (2) (3)
Note:
(1) Order of steps in procedure. When reassembling,
follow the steps in reverse order. These numbers
are also used as the Identification (location) No. of
parts in figures.
(2) Parts to be removed or installed.
(3) Fig. No. showing procedure of part location
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
CN = Connector
* = Unhook, Unlock, Release, Unplug, or Desolder
e.g. 2(S-2) = two Screws (S-2),
2(L-2) = two Locking Tabs (L-2)
(5) Refer to the following "Reference Notes in the
Table."
4-1
Removal
Remove/*Unhook/
Unlock/Release/
Note
Unplug/Unclamp/
Desolder
---
↓ ↓
(4) (5)
L2601DC