Replacing The Light Bulb - GE GCS04 Owner's Manual And Installation

Care and cleaning.
C
Replacing the light bulb (available on some models)
In the Event of a Power Failure
If the power fails, open the door as
infrequently as possible to maintain
the temperature. A gradual rise in
temperature should not have any
adverse effect on the beverage.
If it is extremely hot, you may want to
unload the beverage from the beverage
centre and move the beverage to a cooler
location until power is restored.
Preparing to Move
Unload the beverages, then secure the
racks and door by taping them in place to
prevent damage.
Unplug the beverage centre.
2
If the door is locked, unlock it.
3
The light bulb is located behind the Light Shield in the ceiling
of the beverage centre near the front. To remove the light shield,
remove Screw. Gently pull down on the bottom of the Light shield to
release it.
4
Unscrew the light bulb from the Socket.
5
Replace with a 10 watt, 120 volt refrigerator bulb. This type of bulb is
available at most hardware and automotive parts stores.
WARNING:
Using a bulb rated higher than 10 watts may damage
the beverage centre
6
Attach the Light Shield to the Bulb Housing with Screw .
7
Plug the beverage centre back in.
www.GEAppliances.ca
When power is restored, the controls
automatically are set to the Factory Setting
41°F (5°C). If needed, reset the controls
to the desired setting.
Be sure the beverage centre stays in an upright
position during the move.
7