Table of Contents
Advertisement
Remove/Install x2 SE Turf Tire/Wheel/Spacer/Hub Adapter
Tools Required: 8 mm hex bit, 13 mm socket wrench, torque wrench
Remove the x2 SE Turf Tire/Wheel/Spacer/Hub Adapter
1.
Make sure the Segway PT is unplugged and powered off.
2.
Tip the PT on its side so the Wheel you want to remove is facing up,
and the bottom wheel rests against a smooth, clean surface.
3.
Holding the wheel to prevent rotation, remove the four 8 mm
fasteners, (see Figure 74).
4.
Remove the tire/wheel assembly, then the spacer.
5.
Remove the three hub adapter nuts using a 13 mm socket wrench,
then remove the hub adapter.
Install the x2 SE Turf Tire/Wheel/Spacer/Hub Adapter
1.
Ensure the PT is unplugged, powered off, is on its side, and the
gearbox flange is clean and free of debris.
2.
Install the hub adapter; torque the three nuts to 30 N-m (22 ft-lbf).
3.
Place the spacer onto the hub adapter.
4.
Place the Tire/Wheel assembly onto the spacer (see Figure 74).
5.
Holding the wheel to prevent rotation, torque the four 8 mm
fasteners to 30 N-m (22 ft-lbf).
8 mm fasteners
Hub adapter nuts
Figure 74: x2 SE Turf Tire/Wheel/Spacer/Hub Adapter
Spacer
Hub adapter
113
Hide quick links:
Advertisement
Table of Contents
