Teledyne 2103 Installation And Operation Manual page 43

Figure 4-9 Connecting an antenna to the 2103
Figure 4-10 Antenna connected to the 2103
To connect an antenna to the 2103
nector shell (Figure 4-9) to loosen its components. Slide the com-
ponents down the cable to reveal the gold connector end.
Twist the connector
shell to loosen its com-
ponents.
Slide the components
down the cable, and
connect the gold
connector end to the
modem.
G
When the gold SMA connector is tightly attached to the modem,
slide the connector shell forward. Press down on the metal latch
on the side of the modem and push the connector shell onto the
modem, as shown in Figure4-10.
modem.
G
Note
When any communication connector is not in use, it should be
capped. The cap will seal the connector to prevent corrosion,
prevent moisture from entering the unit, and improve communi-
cations.
Note
For the transmitter to comply with FCC Maximum Permissible
Exposure (MPE) regulations, the antenna needs to be located
a minimum of 30 centimeters (12 inches) from the human
body.
2103 Modem Module
Section 4 2103G Cellular Modem Module
, twist the protective con-
G
4-7