Server Blade Handle - HP ProLiant BL30p Maintenance And Service Manual

Removal and Replacement Procedures

Server Blade Handle

The server blade handle contains a serial number that maintains the original server blade
warranty. In the event that the system board assembly is replaced, the original handle must be
removed, and attached to the new server blade system board assembly. To remove the server
blade handle:
1. Power down the server blade and remove it from the server blade enclosure. Refer to
"Server Blad e Preparation" in this chapter.
2. Remove the screw attaching the handle to the server blade.
3. Remove the handle. Be sure to keep the screw and the spring that is underneath the
handle for replacement onto the new system board assembly.
Figure 2-24: Removing the server blade handle
To replace the server blade handle:
1. Place the handle over the spring on the server blade.
2. Attach the screw to secure the handle and spring.
2-22 HP ProLiant BL30p Server Blade Maintenance and Service Guide