WynMax WMIX-D5256 User Manual page 27

□ OnChip IDE Device
Press <Enter> to set IDE and SATA device configuration.
IDE HDD Block Mode
IDE DMA transfer access
*** On-Chip Serial ATA Setting ***
SATA Mode
On-Chip Serial ATA
*** On-Chip PATA Setting ***
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
↑ ↓ ← → :Move
F5: Previous Values
□ IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write.
□ IDE DMA transfer access
UDMA (Ultra DMA) is a DMA data transfer protocol that utilizes ATA commands and
the ATA bus to allow DMA commands to transfer data at a maximum burst rate of 33
MB/s.
□ On-Chip Serial ATA Setting
There have three selections in "SATA mode":
 IDE: Default
 RAID: Set this item to enable SATA AHCI function for WinXP-SPI+IAA driver
support AHCI mode.
 AHCI: Enable SATA RAID function
Phoenix – AwardBIOS CMOS Setup Utility
OnChip IDE Device
Enter:Select +/-/PU/PD:Value
F6: Fail-Safe Defaults
[ Enabled ]
[ Enabled ]
[ IDE ]
[ Enhanced Mode ]
[ Enabled ]
[ Auto ]
[ Auto ]
[ Auto ]
[ Auto ]
[ Enabled ]
[ Auto ]
[ Auto ]
[ Auto ]
[ Auto ]
F10:Save ESC:Exit
F7: Optimized Defaults
27
Item Help
Menu Level
If your IDE hard drive
supports block mode
select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support.
F1: General Help