Related Manuals for Niles TVC-1
Summary of Contents for Niles TVC-1
- Page 1 I N S T A L L A T I O N & O P E R A T I O N G U I D E TVC-1 TVC-1 TABLETOP STEREO VOLUME CONTROL ® L E N D I N G...
-
Page 2: Table Of Contents
TVC-1 Tabletop Stereo Volume Control Introduction TABLE OF CONTENTS The TVC-1 is a tabletop volume control for speakers. It con- Introduction nects between the speaker-level output of an amplifier, speak- er selector, etc. and a pair of speakers. Features and... -
Page 3: Features And
O L U M E O N T R O L Features and Benefits The TVC-1 offers a number of improvements over other tabletop volume controls: • Power handling: 100 watts per channel RMS; 200 watts peak • Selectable impedance magnification for 1, 2, 3/4, 5/6 pairs... - Page 4 1. Count the number of pairs of speakers you are connecting to the system. 2. Set the Speaker Pairs switch on the rear panel of the TVC-1 to match the number of pairs of speakers (1, 2, 3/4, 5/6). TVC-1 Power Handling...
- Page 5 O N T R O L Type of Speaker Wire For most applications, we recommend you use 16 or 18 gauge, stranded copper speaker wire for the TVC-1 con- nections. For wiring runs longer than 80 feet, 14 gauge wire TOOLS is recommended.
-
Page 6: Installation
AWG 1. Select a convenient location for the TVC-1. (American Wire Gauge) 2. Run all the necessary wiring to the TVC-1. Label the wires number. The lower for future reference. See (Figure 1). the AWG number, 3. Locate the connector plugs (and remove them if they are the larger the wire, plugged in). - Page 7 O N T R O L Recessed area for custom TVC-1 TABLETOP VOLUME CONTROL room labels. Attractive low-profile design. 12 position volume control provides greater attenuation than conventional 10 position designs. Niles Audio Corporation Miami, Florida USA AMPLIFIER SPEAKER SPEAKER PAIRS Removable screwless connectors...
-
Page 8: Installation
NOTE: To help you avoid improper installation, the connector plug is keyed. Receiver TUNER 94.9 Figure 1 Wiring Diagram Niles TVC-1 Niles Audio Corporation Miami, Florida USA AMPLIFIER SPEAKER SPEAKER PAIRS Speaker Pair... - Page 9 “SPEAKERS”. Be sure not to reverse these connec- tions or the TVC-1 will not function properly. 8. Locate the pre-printed Room Labels. Affix the appropriate label to the recessed area next to the knob on the TVC-1. Figure 2 Connecting the...
-
Page 10: Operation
6. Using the knob on the front of the TVC-1, adjust the vol- ume of the speakers to the desired listening level. 7. You can turn off the speakers by turning the knob on the TVC-1 fully counter-clockwise, or by pressing the on/off button on your speaker selector. -
Page 11: Specifications
If all the speaker pairs in your system are 2-conductor speaker equipped with Niles volume controls, you can leave the ampli- wire. Connectors fier or receiver volume set at one position and use the Niles accommodate wire controls exclusively. sizes 14-22 gauge... - Page 12 12331 S.W. 130 Street Miami, Florida 33186 © 2004 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the Tel: (305) 238-4373 quality of its products, Niles reserves the right to change product specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation.