How To Operate - Vax Ultra handvac Instruction Manual

V-044B Infinity By Vax User Guide.qxd:V-044B Infinity User Guide

4. How to Operate

Turn the vacuum cleaner on by pressing the on/off switch
located on the lower right side of the cleaner (Fig.4/1).
On/ off
switch
Fig.4/1
The cleaner can be turned off by pressing the on/off
switch again.
Adjusting the Angle of the Main Body
To adjust the angle of the vacuum cleaner body, push the
release pedal on the lower left side of the cleaner (Fig.4/2).
Move the handle to the desired position. (A) for
upright position, (B) for normal operation and (C) to clean
under furniture (Fig.4/2).
Press here
Fig.4/2
Carpet Height Adjuster
The front of the vacuum cleaner has a carpet height
adjuster that raises and lowers the brushbar to suit the
type of carpet. With the cleaner NOT connected to the
electrical outlet, set the adjustment to the lowest setting
for maximum cleaning. If the cleaner is difficult to move,
push the knob to the next highest setting until the
vacuum is comfortable to push. The brushbar must reach
the carpet for effective cleaning.(Fig.4/3).
Fig.4/3
!
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE: Vax recommends that you raise the height of
A
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
B
these surfaces if the customer fails to take notice of
this recommendation.
C
!
tools, the carpet height adjuster must be set to the
highest position.
!
any moving part (such as the brushbar). Turn off the
switch and unplug the cleaner before adjusting the
cleaner for the carpet height.
18/6/09
Vax Careline
WARNING: This cleaner has a constantly
rotating brush bar which, when left in contact
IMPORTANT: When the vacuum cleaner is stood in
the upright position or when using the hose and
WARNING: To avoid injury, keep loose clothing, hair,
fingers and all other parts of the body away from
16:04 Page 5
0870 606 1248
5
operation