Programming New Or Replacement Transmitters (Bank 1) - Audiovox Pursuit PRO9644i Owner's Manual

PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)

Transmitter Model Name Is Found On Back Of Transmitter Case
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (Siren Chirps).
3. Press the Lock Button of each transmitter you want programmed until you
hear a chirp from the horn or siren.
4. Turn the ignition switch off.
The above action programs the Lock, Unlock, and the Start/Trunk button which
are typical for most 3 button systems.
For additional channel programming beyond the trunk/start function, if available
on your system, you can use any unused button or combination of buttons not in
use.
In other words, to access option channel 5, 6, 7, you would do the following:
From step 3 above:
a. Press and release the valet/programming button 4 additional times to get to
channel 5, then Press any unused transmitter button or button combination
to program.
b. From a, press and release the valet/programming button 1 time to get to
channel 6, then press any unused transmitter button or button combination to
program.
c. From b, press and release the valet/programming button 1 time to get to
channel 7, then press any unused transmitter button or button combination to
program.
NOTE: Not all systems have channels above 3, check with your installation
center for options your system may or may not have.
NOTE: Certain systems have the ability to utilize channels 6 & 7 for driver
priority programming. For driver priority, the vehicle must be equipped
with this feature, and the optional feature must be set up and installed
by your installation center. Once this feature is added when the unlock
button of transmitter 1 is used, it will set driver 1 priority, and when the
unlock button of transmitter 2 is used it will set driver 2 priority. In this
situation, the unlock button can be programmed into two receiver chan-
nels, unlock, channel 2 and driver priority 6 or 7. In no other circum-
stance will the system allow a transmitter button to be programmed into
2 receiver channels at the same time.
Page 14
128-8699b
14 of 16