Adding An Item During A Cycle; Using Delay Wash; The Clean Signal Light - Whirlpool 900 SERIES Use & Care Manual

Adding an item during a cycle
You can add an additional item to the
dishwasher anytime before the cycle control
knob reaches Light. items added after the
cycle control knob reaches Light may only
be rinsed.
1.
Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
3. Close the door, but
do not
latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
2. Open the door and add the item.
Using delay wash
(on some models)
You can set the dishwasher to start a cycle
from 1 to 4 hours later.
1.
Press the desired Cycle pad.
2. Press the desired Option pad(s).
3. Turn the cycle control knob clockwise to
the number of hours (from 1 to 4 hours)
you want the dishwasher to delay before
the selected cycle starts.
4. Close and latch the door. The Delay/
Water Heating signal light will come on
until the selected cycle starts.
NOTE:
l
You can add items while time is counting
down. Close and latch the door. The cycle
control knob will not advance if the door is
unlatched.
l
Rinse-Wash Later and Light cycles cannot
be delayed.
l
The Delay/Water Heating signal light will
also come on while the water is heating
during all cycles.
The clean signal light
(on some models)
The Clean signal light will come on when a
washing cycle is complete. To turn it off, turn
the cycle control knob clockwise
slightly
until the light goes off.
18