Montigo R320 Installation & Maintenance Manual page 18

R320 & R420 Power Vent Indoor Gas Fireplace
Inset
Electrical Harness
Connector Location
Figure 11b. Installing the Rough-in Kit.
Step 4: Install screws around perimeter of Rough-in Kit. Drill holes supplied
for ease of installation, see Figure 11c.
Figure 11c. Fasten Rough-in Kit to framing
Step 5: Install the Power Vent Roof top stainless steel cover over the
installed Rough-in Kit, see Figure 11d. The Electrical connector is located
in the corner, see Figure 11e.
Figure 11d. Installed stainless steel cover.
Page 18
Installation
Power Vent
Rough-in Kit
Electrical Harness
Install Fasteners around
perimeter of Rough-in Kit
Step 6: Install the Power Vent module power harness. Hold the Power
Vent in close proximity to the assembled chase. With stainless steel cover
attached, plug in the power harness. Note the direction and orientation of
the plug socket, see Figure 11e.
Electrical Harness
from Power Vent
Figure 11e. Installed power harness.
Step 7: Install the Power Vent module. Place the Power Vent module over
the stainless steel cover flange and vent pipe. Align the Power Vent into final
position. Ensure the power harness is placed down in the rough-in box. The
Power Vent module will sit flush with the stainless steel cover when installed
correctly, see Figure 11f.
Install Power Vent Module
with Power Harness
Figure 11f. Installing Power Vent module.
Step 8: Secure the Power Vent module with three stainless steel fasteners
angled at 120°, penetrating through the inner stainless steel vent cover,
see Figure 11g.
Figure 11g. Completed Power Vent module installation.
Vertical Roof Top
Power Vent
Vertical Roof Top
Power Vent Rough-in
Kit
Stainless Steel
Fasteners
XG0770 - 040513.2