Basic Operation; What To Do In Emergencies; Error Code Summary And Explanation - GEM e2 2005 Owner's Manual

Operation and Maintenance

BASIC OPERATION

This is a basic list of how to operate the vehicle.
1. Make sure the disconnect switch is in the "ON" position.
2. Turn key switch on.
3. Fully release the parking brake.
4. Move direction switch to desired position.
5. Press accelerator pedal and go.

WHAT TO DO IN EMERGENCIES

Error Code Summary and Explanation

Error codes are used in the control system to indicate conditions that
prevent the vehicle from operating. All error codes are accompanied by the
service icon. The chart shown below summarizes the most frequent error
codes and remedies.
Error Code
-06
-11
-15
-16
GEM Owner's Manual - Page 44
Condition
Pedal depressed and no direction
is selected.
Key on while pedal is pressed
Low voltage on battery pack
High voltage on battery pack
Remedy
Release pedal and insure direction switch
is "locked" into a position.
Release accelerator pedal
Need to charge batteries before operating
Turn lights on for several seconds, then
turn key switch on and off.