Rear Panel Connections - Topfield TBC-2010 User Manual

2.3 Rear panel connections

• The wall socket should be near the equipment. Do not
run an extension lead to the unit.
• The mains plug shall remain readily operable so that it
can be removed easily to disconnect the power.
• When placed in a cabinet, make sure there is a minimum
space of 10 centimetres around it. For the physical spec-
ification of the digital receiver, refer to Table 2.2.
• Protect the power cord from being walked on or pinched.
If the cord is damaged, do not use the digital receiver and
get the cord replaced.
• Refer all servicing to a qualified service technician.
• To maintain proper ventilation, always leave sufficient
space around the digital receiver.
Table 2.1: Power specification
Input voltage
Power consumption
Table 2.2: Physical specifications
Size
Weight
Operating temperature
Storage relative humidity
The TBC-2010 has the following connections on the back:
2.3 Rear panel connections 9
90 to 250 V AC, 50/60 Hz
22 W at maximum in active
Under 1 W in passive standby
260× 46× 190 mm
1.2 kg
◦
0 to 45 C
5 to 90 %