Removal / Replacing Jet Parts - European Touch Petite Spa Owner's Manual

Tools required:
Pliers
7/8" deep well socket with extension
Check your state and local regulations for cleaning procedures. Links to your state boards can
be found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page
headed "Cleaning your Petite Spa," page 12, for cleaning recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: Remove the jet eyeball using the
pliers. Pull forward with a quick tug.
Step 2: Remove the adjusting cover.
This should pull out.
Doc ID: 01080001

Removal / Replacing Jet Parts

Step 3: Remove the jet nozzle and nut using a
7/8" deep-well socket and extension.
Step 4: For cleaning, refer to "Cleaning your
Petite Spa" on page 12. Reassemble the jet
assembly. The jet nozzle nut should be hand
tightened using the socket with extension. If the
adjustment cover is hard to turn, slightly loosen
the jet nozzle nut.
Step 5: Reverse steps to reassemble.
Revision: B Technical Support: 800-626-6912
Clean this area, using low
foaming soap and
disinfectant, with a brush.
Remove all visible residue
and rinse with clean water.
Page 13