Advertisement
I
NSTALLATION
Figure 5A. Mounting the tweeter using the
I-Mount
™
flush-mounting kit.
–
blk
+
red
1) push in
2) turn
Figure 5B. Aiming the tweeter at a desired
listening position.
3
ROTATE TO AIM
ANGLED TWEETER
TOWARD LISTENER.
1
SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
2
TIGHTEN NUT AND
WASHER TO LOCK
ANGLE SETTINGS.
4
SECURELY TIGHTEN
THE LARGE HAND NUT.
Figure 6. Mounting the tweeter using the
I-Mount™ surface-mounting kit.
blk
–
+
red
1
2
C
ONNECTIONS
Open the crossover housing by placing your
fingers between the terminals and the top cover,
and gently pulling off the cover. Using screws or
a wire tie, mount the crossover through the holes
provided. Observing proper polarity, connect the
speakers and amplifier as shown in 7A and 7B.
Replace the cover when you are finished making
connections and adjustments.
Figure 7A. Wiring connections on the crossover
network (shown with cover on).
p/s 050
2ohm
5.4uF
6.8uF
2ohm
0.22mH
-
IN
+
-
WF
+
-
TW
+ -3dB
Red
To AMPLIFIER
To TWEETER
SPEAKER OUTPUTS
To WOOFER
Blk
Figure 7B. Locating wiring connections on the
50.5cs woofer. Other woofers are wired similarly.
Big Lug =
Small Lug =
Infinity Kappa component crossovers include a
"Custom Contour™" adjustment. Custom Contour,
if enabled, will reduce the midrange output from
the system, resulting in more perceived bass and
high frequency. You may choose the setting that
best suits your listening perference. The default
position is "Flat" .
Figure 7C. Enable Custom Contour by moving the
jumper (located in the upper-left corner, inside the
crossover housing) to connect the two left pins.
Defeat Custom Contour by moving the jumper to
connect the two right pins.
Contour
Contour
Flat
Flat
Flat
Contour
- 3 -
Advertisement
