Appendix C. Notices; Electronic Emission Notices; Federal Communications Commission (Fcc) Statement - IBM Digital Pen User Manual

Appendix C. Notices

References in this publication to IBM products, programs, or services do not
imply that IBM intends to make these available in all countries in which IBM
operates. Any reference to an IBM product, program, or service is not intended
to state or imply that only that IBM product, program, or service may be used.
Any functionally equivalent product, program, or service that does not infringe
any of the intellectual property rights of IBM may be used instead of the IBM
product, program, or service. The evaluation and verification of operation in
conjunction with other products, except those expressly designated by IBM, are
the responsibility of the user.
IBM may have patents or pending patent applications covering subject matter
in this document. The furnishing of this document does not give you any
license to these patents. You can send license inquiries, in writing, to the IBM
Director of Licensing, IBM Corporation, North Castle Drive, Armonk NY
10504-1784, U.S.A.

Electronic emission notices

Federal Communications Commission (FCC) Statement

IBM ThinkPad TransNote Digital Pen (NEJNT1)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
v Reorient or relocate the receiving antenna.
v Increase the separation between the equipment and receiver.
v Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
v Consult an IBM authorized dealer or service representative for help.
C-1
© Copyright IBM Corp. 2000