Connecting The Keyboard To Your Computer; Connecting The Keyboard To A Usb Port; Installing The Usb Hardware Device; Installing The Rapid Access Iii Usb Keyboard Software - IBM Rapid Access III USBKeyboard User Manual

Connecting the keyboard to your computer

This section provides information on connecting the keyboard.

Connecting the keyboard to a USB port

To connect your keyboard to a computer USB port, attach the keyboard
connector to the computer USB port, as shown.

Installing the USB hardware device

To install the USB device, do the following:
1. After you have connected the keyboard, it will automatically be detected by
your operating system. The Add New Hardware window may appear. If
so, follow the on-screen instructions.
2. After the USB device has been installed, go onto installing the software.

Installing the Rapid Access III USB Keyboard software

To install the Rapid Access III USB Keyboard software, insert the Rapid Access
III USB Keyboard CD into your CD-ROM or DVD-ROM drive. The Rapid
Access Keyboard Installation window opens. Follow the instructions on your
screen to complete the installation. If the installation software does not open
automatically, do the following:
1. Click Start --> Settings --> Control Panel.
2. Double-click Add/Remove Programs.
3. Follow the instructions on your screen to complete the installation.
4. Restart Windows.
Note: When you have restarted Windows, a 301 error message might
appear on your screen. Disregard this error message; it occurs
automatically when there is no keyboard plugged into the PS/2
keyboard port.
5. The Rapid Access icon should appear in the desktop tray and in the
Control Panel.
A-2
Rapid Access III USB Keyboard: User's Guide