Assembly; Fitting The Hand Guard And Loop Handle; Fitting The Handle; Adjusting The Harness - Husqvarna 325HE3 X-series Operator's Manual

Fitting the hand guard and loop
handle
(325HE3)
1 Slide the spacer into the slot in the loop handle.
2 Fit the nut and screw. Do not overtighten.
3 Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
CAUTION! The loop handle and hand guard must not
be fitted behind the arrow marked on the shaft.

Fitting the handle

Fit the handle using two screws.
10 – English

ASSEMBLY

Adjusting the harness

(325HE4)
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back.
1 Put on the harness.
2 Hook the machine onto the harness support hook.
3 Adjust the length of the harness so that the support
hook is roughly level with your right hip.

Fitting the impact guard

(325HE4)
Fit the guard using the three screws and washers. Fit the
two short screws in hole A. Tighten the screws to a torque
of 4 Nm. After the machine has been in use for around 20
hours, re-tighten the screws to 4 Nm.