Specifications; Instructions For Putting Into Use - SWS Power Tools 66630 Set Up And Operating Instructions Manual

SPeciFicatiOnS

Electrical Requirements
Motor No Load Speed
Blade Diameter
Arbor Diameter
Table Surface
Cutting Depth at 0°
Cutting Depth at 45°
Overload Protection
unPacKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
inStructiOnS FOr
Putting intO uSe
read the entire iMPOrtant
SaFety inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
FrOM acciDental
OPeratiOn:
turn the Power Switch of the
tool to its "OFF" position,
remove key, and unplug the
tool from its electrical outlet
before assembling or making
any adjustments to the tool.
SKU 66630
120 V~ / 60 Hz / 15 A
4800 RPM
10"
5/8"
16"x 26"
3"
2-3/8"
Breaker Switch
e105017
tO Prevent
SeriOuS injury
For technical questions, please call 1-800-444-3353.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
To Install Handwheel (29)
1. Remove the Bolt (27) from the Screw
Rod (54).
2. Place the Handwheel onto the Screw
Rod. Fasten into place by using the
Bolt.
To Assemble Blade Guard (113)
1. Unplug the Saw and remove the
Switch Key (16).
2. Position the Blade (96) 90° to the
table and lock in place.
3. Position the recessed end of the
Splitter Bracket (119) against the end
of the Pivot Plate (117) and fasten in
place using the Spring Washer (3),
Mat Washer (4) and Bolt (116).
Please note: Do not fully tighten the Bolt
at this time.
4. Remove the Wing Nut (121), Flat
Washer (50) and Spring Washer (3)
from Splitter Bracket.
5. Position the Splitter (131) against the
Splitter Bracket. Make sure the tabs
on the Splitter Bracket are INSIDE
the slot of the Splitter.
6. Replace the Wing Nut (121), Flat
Washer (50) and Spring Washer (3).
7. Make sure there is at least a 1/8" gap
between the bottom edge of the Split-
ter and the top surface of the Table
Page 10