Specifications; Instructions For Putting Into Use; Operating Instructions - Drill Master 67032 Set Up And Operating Instructions Manual

speciFications

Battery Type 18V NiCd - SKU 67029
Charger SKU 67031
Bulb 10W incandescent, XPR-18
Accessories Spare Bulb in Lamp Head Housing
unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
instructions For
putting into use
read the entire important
saFetY inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
note: For additional information regarding
the parts listed in the following pages,
refer to the Parts List and Assembly
Diagram near the end of this manual.
Functions
Lamp Head Housing (7)
Lens Retainer (15)
Battery Pack
(SKU 67029)
(Sold Separately)
SKU 67032
Power Switch (2)
Figure 1
For technical questions, please call 1-800-444-3353.

operating instructions

tool set up
From accidental
operation:
turn the power switch of the
tool to its "oFF" position and
disconnect the tool from its
Battery pack before
performing any inspection,
maintenance, or cleaning
procedures.
charge the Battery
The Charger (SKU 67031) and
Rechargeable Battery Pack (SKU
67029) are sold separately. Please
refer to the 67031 Charger manual
for important safety warnings and
proper instructions on charging tool.
Warning! Do NOT use a different
Charger or Battery Pack to power this
tool.
general operating instructions
1. Attach the fully charged Battery Pack
(sold separately) to the base of the
Flashlight.
2. Slide the Power Switch (2) to ON
by sliding it towards the Lamp Head
Housing (7).
3. Adjust the direction of the light by
pivoting the Lamp Head Housing (7)
of the light clockwise, up to 90°.
4. Turn off the Flashlight and disconnect
its power supply after use. Clean,
then store the tool indoors out of chil-
dren's reach.
to preVent
serious injurY
Page 5