Replacing The Light Bulb; The Exhaust Feature - GE PVM9215 Owner's Manual

Replacing the light bulb.

Sensor Microwave
Family Snacks
Steam Defrost
Cooking A dd
Menu 30 S ec
C Start
Back ancel
O ff Pause
Lock Controls
Hold 3 Sec
Settings Power Saver
Timer Vent Surface
On/Off Fan Light
Remove screw.
Sensor Microwave
Family Snacks
Steam Defrost
Cooking A
dd
Menu 30 S
C ancel Start
Back
O ff Pause
Lock Controls
Hold 3 Sec
Settings Power Saver
Timer Vent Surface
On/Off Fan
About the exhaust feature.
Charcoal filter (on some models).
Sensor Microwave
Family Snacks
Steam Defrost
Cooking A dd
Menu 30 S ec
C ancel Start
Back
O ff Pause
Lock Controls
Hold 3 Sec
Settings Power Saver
Timer Vent Surface
On/Off Fan Light
Reusable vent filters
(on all models).
Steam Defrost
Cooking A
dd
Menu 30 S ec
C ancel Start
Back
O ff Pause
Lock Controls
Hold 3 Sec
Settings Power Saver
Timer Vent Surface
On/Off Fan Light
Cooktop Light/Night Light
Replace with a 120 volt, 25 or 50 watt (max.)
halogen bulb. Order WB36X10213 from your
GE supplier.
1
To replace the cooktop light/night light, first
disconnect the power at the main fuse or
circuit breaker panel, or pull the plug.
2 Remove the screw from the side of the light
compartment cover and lower the cover
until it stops.
ec
Light
Vent Fan
The vent fan has two metal reusable vent filters.
Models that recirculate air back into the room
also use a charcoal filter.
Reusable Vent Filters
The metal filters trap grease released by foods
on the cooktop. They also prevent flames from
foods on the cooktop from damaging the inside
of the oven.
Removing and Cleaning the Filters
To remove, slide them to the rear using the
tabs. Pull down and out.
To clean the vent filters, soak them and then
swish around in hot water and detergent. Don't
use ammonia or ammonia products because
they will darken the metal. Light brushing can
be used to remove embedded dirt.
3 Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
4 Screw in the new bulb, then raise the light
cover and replace the screw. Connect
electrical power to the oven.
For this reason, the filters must always be in
place when the hood is used. The vent filters
should be cleaned once a month, or as needed.
Rinse, shake and let dry before replacing.
To replace, slide the filters into the frame slots
on the back of each opening. Press up and to
the front to lock into place.
GEAppliances.ca
21