Toshiba MV20FK3 Service Manual page 16

2-19: LOADING GEAR S/T ASS'Y (Refer to Fig. 2-19-A)
Remove the E-Ring 1 and remove the Main Loading
1.
Gear.
Remove the Capstan Brake Spring.
2.
3. Slide the Main Rod and remove the Capstan Brake
Ass'y.
4. Remove the Main Rod, Tension Lever, Clutch Actuator,
Idler Arm Ass'y.
Remove the screw 2.
5.
6. Remove the LED Reflecter.
7. Remove the Loading Arm S Ass'y and Loading Arm T
Ass'y.
8.
Remove the Loading Gear S and Loading Gear T.
9.
Remove the Loading Gear Spring.
Capstan Brake Spring
Main Rod
Idler Arm Ass'y
LED Reflecter
Clutch Actuator
• Screw Torque: 5 ± 0.5kgf•cm
NOTES
1. When you install the Loading Arm S Ass'y, Loading Arm
T Ass'y and Main Loading Gear, align each marker.
(Refer to Fig. 2-19-B)
Main Loading Gear
Marker
Loading Arm T Ass'y
DISASSEMBLY INSTRUCTIONS
Capstan Brake Ass'y
1
Main Loading Gear
Tension Lever
Loading Gear T
Loading Gear
2
Spring
Loading Arm T Ass'y
Loading Gear S
Loading Gear
Spring
Loading Arm S Ass'y
Fig. 2-19-A
Marker
Loading Arm S Ass'y
Fig. 2-19-B
2. When you install the Clutch Actuator, install as shown in
the circle of Fig. 2-19-C. (Refer to Fig. 2-19-C)
Clutch Actuator
2-20: INCLINED S/T ASS'Y (Refer to Fig. 2-20)
Unlock the support 1 and remove the P4 Cover.
1.
Remove the screw 2.
2.
Unlock the support 3 and remove the Loading Gear
3.
Holder.
4. Remove the Inclined S.
5. Remove the Inclined T.
Remove the 2 screws 4, then remove the Guide Roller.
6.
NOTE
Do not touch the roller of Guide Roller.
Guide Roller
4
Inclined S
• Screw Torque: 5 ± 0.2kgf•cm (Screw 2)
• Screw Torque: 0.7 ± 0.2kgf•cm (Screw 4)
Fig. 2-19-C
2
Loading Gear Holder
3
Guide Roller
4
Inclined T
P4 Cover
1
Fig. 2-20