Spark Plug; Lubricating The Bar Tip Sprocket; Needle Bearing Lubrication; Adjustment Of The Oil Pump - Husqvarna 365 X-Torq Operator's Manual

Hide thumbs Also See for 365 X-Torq:
Table of Contents

Advertisement

against the filter holder. Clean the filter by brushing or
shaking it.
The filter can be cleaned more thoroughly by washing it in
water and detergent.
An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.
A HUSQVARNA chain saw can be equipped with different
types of air filter according to working conditions, weather,
season, etc. Contact your dealer for advice.

Spark plug

The spark plug condition is influenced by:
Incorrect carburettor adjustment.
An incorrect fuel mixture (too much or incorrect type of
oil).
A dirty air filter.
These factors cause deposits on the spark plug
electrodes, which may result in operating problems and
starting difficulties.
If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking any further action. If the spark plug is dirty,
clean it and check that the electrode gap is 0.5 mm. The
spark plug should be replaced after about a month in
operation or earlier if necessary.
Note! Always use the recommended spark plug type! Use
of the wrong spark plug can damage the piston/cylinder.
Check that the spark plug is fitted with a suppressor.
MAINTENANCE

Lubricating the bar tip sprocket

Lubricate the bar tip sprocket each time you refuel. Use
the special grease gun and a good quality bearing grease.

Needle bearing lubrication

The clutch drum has a needle bearing on the output shaft.
This needle bearing must be lubricated regularly (once a
week). CAUTION! Use a high-quality bearing grease or
engine oil. See instructions under the heading Cutting
equipment.

Adjustment of the oil pump

The oil pump is adjustable. Adjustments are made by
turning the screw using a screwdriver or combination
spanner. The machine is supplied from the factory set to
1 turn open. Turning the screw clockwise will reduce the
oil flow and turning the screw anti-clockwise will increase
the oil flow.
Recommended settings:
Bar 16"-18" 2 turns from the closed position.
Bar 20"-24": 3 turns from the closed position.
Bar 28" - :
These recommendations apply to Husqvarna's chain oil,
for other chain oils increase the oil flow by one step.
!
4 turns from the closed position.
WARNING! The engine must not be
running when making adjustments.
English
35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

372xp x-torq372xpg x-torq

Table of Contents